HP PROCURVE 2520 Management And Configuration Manual page 162

Interface Access and System Information
System Information
Reconfigure the MAC Age Time for Learned MAC Addresses. This
command corresponds to the MAC Age Interval in the menu interface, and is
expressed in seconds.
Syntax: mac-age-time < 60 - 999960> (seconds)
For example, to configure the age time to seven minutes:
ProCurve(config)# mac-age-time 420
Configure the Time Zone and Daylight Time Rule. These commands:
■
■
Syntax: time timezone < -720 - 840 >
East of the 0 meridian, the sign is "+". West of the 0 meridian, the sign is "-".
For example, the time zone setting for Berlin, Germany is +60 (zone +1, or 60
minutes), and the time zone setting for Vancouver, Canada is -480 (zone -8, or
-480 minutes). To configure the time zone and daylight time rule for Vancouver,
Canada:
ProCurve
daylight-time-rule continental-us-and-canada
Configure the Time and Date. The switch uses the time command to
configure both the time of day and the date. Also, executing time without
parameters lists the switch's time of day and date. Note that the CLI uses a 24­
hour clock scheme; that is, hour (hh) values from 1 p.m. to midnight are input
as 13 - 24, respectively.
Syntax: time [ hh:mm [ :ss ]] [ mm/dd/ [ yy ] yy ]
For example, to set the switch to 9:45 a.m. on November 17, 2002:
ProCurve(config)# time 9:45 11/17/02
7-16
Allows you to set the MAC address table's age-out interval. An
address is aged out if the switch does not receive traffic from that
MAC address for the age-out interval, measured in seconds.
Default: 300 seconds.
Set the time zone you want to use
Define the daylight time rule for keeping the correct time when daylight-
saving-time shifts occur.
time daylight-time-rule < none | alaska | continental-us-and-canada |
middle-europe-and-portugal | southern-hemisphere | western-europe |
user-defined>
time timezone -480
(config)#