Viewing Port Utilization Statistics; Viewing Transceiver Status - HP PROCURVE 2520 Management And Configuration Manual

Port Status and Configuration
Viewing Port Status and Configuring Port Parameters

Viewing Port Utilization Statistics

Use the show interface port-utilization command to view a real-time rate display
for all ports on the switch. The following shows a sample output from this
command.
ProCurve(config)# show interfaces port-utilization
Status and Counters - Port Utilization
Port Mode
--------- -------- + ---------- ---------- ----- + ---------- ---------- -----
1 100FDx
2 10FDx
3 10FDx
4 10FDx
5 10FDx
6 10FDx
7 100FDx
8 10FDx
9 1000FDx
10 1000FDx
Figure 10-7. Example of a Show Interface Port-Utilization Command Listing
Operating Notes:
■
■

Viewing Transceiver Status

The show tech transceivers command allows you to:
■
10-14
Rx
| --------------------------- | ---------------------------
| Kbits/sec Pkts/sec
| 0 0
| 0 0
| 0 0
| 0 0
| 0 0
| 0 0
| 624 86
| 0 0
| 0 0
| 0 0
For each port on the switch, the command provides a real-time display
of the rate at which data is received (Rx) and transmitted (Tx) in terms
of kilobits per second (KBits/s), number of packets per second (Pkts/
s), and utilization (Util) expressed as a percentage of the total band­
width available.
The show interfaces <port-list> command can be used to display the
current link status and the port rate average over a 5 minute period.
Port rates are shown in bits per second (bps) for ports up to 1 Gigabit;
for 10 Gigabit ports, port rates are shown in kilobits per second
(Kbps).
Remotely identify transceiver type and revision number without having
to physically remove an installed transceiver from its slot.
Tx
Util | Kbits/sec
0 | 0
0 | 0
0 | 0
0 | 0
0 | 0
0 | 0
00.62 | 496
0 | 0
0 | 0
0 | 0
Pkts/sec Util
0 0
0 0
0 0
0 0
0 0
0 0
0 00.4
0 0
0 0
0 0