HP PROCURVE 2520 Management And Configuration Manual page 205

Enabling TimeP in DHCP Mode. Because the switch provides a TimeP
polling interval (default: 720 minutes), you need only these two commands for
a minimal TimeP DHCP configuration:
Syntax: timesync timep
Syntax: ip timep dhcp
For example, suppose:
■
■
The commands and output would appear as follows:
Figure 9-16. Example of Enabling TimeP Operation in DHCP Mode
Selects TimeP as the time synchronization method.
Configures DHCP as the TimeP mode.
Time synchronization is configured for SNTP.
You want to:
1. View the current time synchronization.
2. Select TimeP as the time synchronization mode.
3. Enable TimeP for DHCP mode.
4. View the TimeP configuration.
1 show timep displays the TimeP configuration and also shows
that SNTP is the currently active time synchronization mode.
2
3
4
show timep again displays the TimeP configuration and shows that TimeP is
now the currently active time synchronization mode.
Time Protocols
TimeP: Viewing, Selecting, and Configuring
9-21