Cli Access To System Information; Task Monitor-Collecting Processor Data - HP PROCURVE 2520 Management And Configuration Manual

CLI Access to System Information

The show system command displays general system information about the
switch.
Syntax: show system [information] ]
ProCurve(config)# show system information
Status and Counters - General System Information
System Name
System Contact
System Location
MAC Age Time (sec) : 300
Time Zone
Daylight Time Rule : None
Software revision
ROM Version
Up Time
CPU Util (%)
IP Mgmt - Pkts Rx : 6,000,531
Pkts Tx : 10,133
Figure B-3. Example of Switch System Information
Task Monitor—Collecting Processor Data
The task monitor feature allows you to enable or disable the collection of
processor utilization data. The task-monitor cpu command is equivalent to the
existing debug mode command "taskusage -d". (The taskUsageShow command
is available as well.)
Displays global system information and operational
parameters for the switch.
information
Displays global system information and operational
parameters for the switch.
: ProCurve Switch
:
:
: 0
: S.14.XX
: S.14.02
: 10 days
: 3
Monitoring and Analyzing Switch Operation
Base MAC Addr
Serial Number
Memory - Total
Free
Packet - Total
Buffers Free
Lowest
Missed
Status and Counters Data
: 001635-b57cc0
: LP621KI005
: 152,455,616
: 110,527,264
: 6750
: 5086
: 5086
: 0
B-7