HP PROCURVE 2520 Management And Configuration Manual page 172

Configuring IP Addressing
IP Configuration
N o t e
The default IP address setting for the DEFAULT_VLAN is DHCP/Bootp. On
additional VLANs you create, the default IP address setting is Disabled.
Syntax:
This example configures IP addressing on the default VLAN with the subnet
mask specified in mask bits.
ProCurve
This example configures the same IP addressing as the preceding example,
but specifies the subnet mask by mask length.
ProCurve(config)# vlan 1 ip address 10.28.227.103/24
This example deletes an IP address configured in VLAN 1.
ProCurve (config) no vlan 1 ip address 10.28.227.103/24
Configure Multiple IP Addresses on a VLAN (Multinetting). The fol­
lowing is supported:
■
■
■
■
Syntax:
For example, if you wanted to multinet VLAN_20 (VID = 20) with the IP
addresses shown below, you would perform steps similar to the following.
(For this example, assume that the first IP address is already configured.)
8-8
[ no ] vlan < vlan-id > ip address <ip-address/mask-length>
or
[ no ] vlan < vlan-id > ip address < ip-address > < mask-bits >
or
vlan < vlan-id > ip address dhcp-bootp
(config)# vlan 1 ip address 10.28.227.103 255.255.255.0
Up to 2048 IP addresses for the switch
Up to 32 IP addresses for the same VLAN
Up to 256 IP VLANs, that is, VLANs on which you can configure IP
addresses
Each IP address on a VLAN must be for a separate subnet, whether on the
same VLAN or different VLANs.
[ no ] vlan < vlan-id > ip address < ip-address/mask-length >
[ no ] vlan < vlan-id > ip address < ip-address > < mask-bits >
IP Address VID
1st address 20
2nd address 20
3rd address 20
IP Address Subnet Mask
10.25.33.101 255.255.240.0
10.26.33.101 255.255.240.0
10.27.33.101 255.255.240.0