Unusual Network Activity; General Problems - HP PROCURVE 2520 Management And Configuration Manual

Troubleshooting

Unusual Network Activity

Unusual Network Activity
Network activity that fails to meet accepted norms may indicate a hardware
problem with one or more of the network components, possibly including the
switch. Such problems can also be caused by a network loop or simply too
much traffic for the network as it is currently designed and implemented.
Unusual network activity is usually indicated by the LEDs on the front of the
switch or measured with the switch console interface or with a network
management tool such as ProCurve Manager. Refer to the Installation Guide
you received with the switch for information on using LEDs to identify unusual
network activity.
A topology loop can also cause excessive network activity. The Event Log
"FFI" messages can be indicative of this type of problem.

General Problems

The network runs slow; processes fail; users cannot access servers or
other devices. Broadcast storms may be occurring in the network. These
may be due to redundant links between nodes.
Duplicate IP Addresses. This is indicated by this Event Log message:
Duplicate IP Addresses in a DHCP Network. If you use a DHCP server
to assign IP addresses in your network and you find a device with a valid IP
address that does not appear to communicate properly with the server or other
devices, a duplicate IP address may have been issued by the server. This can
occur if a client has not released a DHCP-assigned IP address after the
intended expiration time and the server "leases" the address to another device.
C-8
• If you are configuring a port trunk, finish configuring the ports in the
trunk before connecting the related cables. Otherwise you may inad­
vertently create a number of redundant links (i.e. topology loops) that
will cause broadcast storms.
• Turn on Spanning Tree Protocol to block redundant links (i.e.
topology loops)
• Check for FFI messages in the Event Log.
ip: Invalid ARP source: IP address on IP address
where: both instances of IP address are the same address, indicating the
switch's IP address has been duplicated somewhere on the network.