Web: Viewing Port Status And Configuring Port Parameters - HP PROCURVE 2520 Management And Configuration Manual

Port Status and Configuration
Viewing Port Status and Configuring Port Parameters
Figure 10-12. Example of Displaying the Current MDI Configuration
ProCurve(config)# show int brief
Status and Counters - Port Status
Port Type
------- --------- + --------- ------- ------ ---------- ----- ----- ------
1 100/100T
2 100/100T
3 100/100T
4 100/100T
5 100/100T
6 100/100T
Figure 10-13. Example of Displaying the Current MDI Operating Mode
Web: Viewing Port Status and Configuring Port
Parameters
In the web browser interface:
1.
2.
3.
4.
Note that the web browser interface displays an existing port trunk group.
However, to configure a port trunk group, you must use the CLI or the menu
interface. For more on this topic, refer to Chapter 12, "Port Trunking" .
10-22
ProCurve(config)# show interfaces config
Port Settings
Port Type
------- --------- + ------- ------------ --------- ----
1 100/100T
2 100/100T
3 100/100T
4 100/100T
5 100/100T
6 100/100T
| Intrusion
| Alert Enabled Status Mode
| No Yes
| No Yes
| No Yes
| No Yes
| No Yes
| No Yes
Click on the Configuration tab.
Click on [Port Configuration].
Select the ports you want to modify and click on [Modify Selected Ports].
After you make the desired changes, click on [Apply Settings].
| Enabled Mode
| Yes Auto
| Yes Auto
| Yes Auto
| Yes Auto
| Yes Auto
| Yes Auto
Per-Port MDI Operating Mode
Down 1000FDx
Down 100FDx
Down 100FDx
Down 1000FDx
Down 1000FDx
Up 1000FDx
Per-Port MDI
Configuration
Flow Ctrl MDI
Disable Auto
Disable MDI
Disable MDIX
Disable Auto
Disable Auto
Disable Auto
MDI Flow Bcast
Mode Ctrl Limit
MDIX off 0
MDI off 0
MDIX off 0
Auto off 0
Auto off 0
Auto off 0