Rx Buffer Clock = Insert (D&I Only); Single-Source Multiple Modems; Figure 10-5. Single-Source Multiple Modems (Looming) - Comtech EF Data CDM-600 Installation And Operation Manual

CDM-600 Satellite Modem
Clock Modes and Drop and Insert (D&I)
10.8 Rx Buffer Clock = Insert (D&I only)
The E1 or T1 clock recovery from the IDI G.703 port serves as the Rx Buffer reference.
In addition, the recovered data is the E1/T1 input to the Insert Mux. If the Rx G.703
recovery circuit detects no activity at IDI input, or cannot detect the expected frame
format, Buffer Clock = Rx Satellite will be chosen as a fall-back.
If 'Insert' is not the selected buffer clock reference, the clock and data from the IDI port
is ignored, and a new E1/T1 frame is generated. The time slots coming from the satellite
are then re-inserted into the selected timeslots of this new blank frame, and output on the
IDO port.
10.9

Single-Source Multiple Modems

Two ways to connect a single T1 or E1 stream to several modems are by looming or
daisy-chaining modems. Each method is illustrated in Figure 10-5 for Looming and
Figure 10-6 for daisy chain and each requires the RX Buffer Clock = Insert setting.
•
•
- - - - - - - - - - Receive
___________ Transmit
Assign all timeslots to not overlap.
Assign modems to number of TX/RX channels as required.

Figure 10-5. Single-Source Multiple Modems (Looming)

BIT ERROR TEST
10–10
Revision 7
MN/CDM600.IOM