Comtech EF Data CDM-600 Installation And Operation Manual page 229

CDM-600 Satellite Modem
ODU Operation
D.2.6 (ODU,ENABLE,1:1,CSAT#1)
(ODU,ENABLE,1:1,CSAT#2)
(ODU,ENABLE,STANDALONE CSAT)
CONFIG: TX-PARAMETERS
Use the [←] or [→] keys to select the parameters to configure, then press ENTER.
D.2.7 (ODU,ENABLE,1:1,CSAT#1,CONFIG)
(ODU,ENABLE,1:1,CSAT#2,CONFIG)
(ODU,ENABLE,STANDALONE CSAT,CONFIG)
TX: FREQ=6427.0 MHz
AMP=OFF
Use the [←] or [→] keys to select the parameter to edit. Use the [↑] or [↓] keys to edit
the parameter, then press ENTER to implement, or CLEAR.
The user may edit the TX Frequency, the TX Attenuation, the Amplifier setting or the
Mute setting. The Slope parameters are edited in another menu, so use the [←] or [→]
keys to select Slope and press ENTER.
D.2.8 (ODU,ENABLE,1:1,CSAT#1,CONFIG,TX)
(ODU,ENABLE,1:1,CSAT#2,CONFIG,TX)
(ODU,ENABLE,STANDALONE CSAT,CONFIG,TX) SLOPE
TX SLOPE:
Use the [←] or [→] keys to select the parameter to edit. Use the [↑] or [↓] keys to edit
the parameter, then press ENTER to implement, or CLEAR.
The Slope Mode may be either CALIBRATED or MANUAL. If MANUAL is selected,
the Slope may be edited.
LNA-PARAMETERS
ATT=23.00 dB
MUTE=UNMUTED
MODE=MANUAL
SLOPE=0.3
D–5
CONFIGURATION
CONFIGURATION
CONFIGURATION
RX-PARAMETERS
MISCELLANEOUS
SLOPE
(MANUAL,CAL)
(0.0 - 1.0)
Revision 7
MN/CDM600.IOM
TX
TX
TX
SLOPE
SLOPE