Comtech EF Data CDM-600 Installation And Operation Manual page 238

CDM-600 Satellite Modem
ODU Operation
D.2.29 (ODU,ENABLE,STANDALONE KST,CONFIG)
TX:OFF
Use the [←] or [→] keys to select the parameter to edit. Use the [↑] or [↓] keys to edit
the parameter, then press ENTER to implement, or CLEAR.
The user may edit the TX Frequency, the TX Attenuation, the Amplifier setting or the
AGC setting.
D.2.30 (ODU,ENABLE,STANDALONE KST,CONFIG)
RX: FREQ=11950 MHz
Note: The RX Band is not shown for the KST-2000A.
Use the [←] or [→] keys to select the parameter to edit. Use the [↑] or [↓] keys to edit
the parameter, then press ENTER to implement, or CLEAR.
The user may edit the RX Frequency, the RX Attenuation, the Ref setting or the RX Band
(KST-2000B only).
D.2.31 (ODU,ENABLE,STANDALONE KST,CONFIG)
HPA:OFF
L NA:OFF
Use the [←] or [→] keys to select the parameter to edit. Use the [↑] or [↓] keys to edit
the parameter, then press ENTER to implement, or CLEAR.
HPA state
FAULT-LOGIC
LNA state
FAULT-LOGIC
CAL
FREQ=13955 MHz
BAND=B
FAULT-LOGIC=SUMMARY
FAULT-LOGIC=SUMMARY
either OFF or ON - HPA power enable
either SUMMARY or NO_SUMMary. This controls whether or not a HPA fault
will be indicated on the Fault status and will activate the Summary Fault
Relay.
either OFF or ON - LNA power enable.
either SUMMARY or NO_SUMMary. This controls whether or not a LNA fault
will be indicated on the Fault status and will activate the Summary Fault
Relay.
To calibrate, select YES and press ENTER. Calibration allows the system to
determine nominal LNB or LNB power consumption, performed at initial
installation only. (Default is NO.)
ATT=23 dB
AGC=OFF
ATT=20 dB REF=087
CAL:NO
D–14
Revision 7
MN/CDM600.IOM
TX
RX
MISC