Part Number - Comtech EF Data CDM-600 Installation And Operation Manual

Comtech EF Data Documentation Update
Subject:
Date:
Document:

Part Number:

Collating Instructions:
Comments:
The following changes affects the values shown on page 15-9.
Change Specifics:
15.2 Miscellaneous
Front panel
Loopbacks
Fault relays
M&C Interface
M&C Software
Dimensions
Weight
AC consumption
Operating voltage
Operating temperature
s:\tpubs\manuals\released_word\modems\cdm600_rev7\errata b.doc
Errata B
Revised Miscellaneous Table
April 18, 2006
CDM-600 Open Network Satellite Modem (2.4 kbps – 20 Mbps)
Installation and Operation Manual
Revision 7, dated February 9, 2005
MN/CDM600.EB7
Attach this page to page 15-9
Tactile keypad, 6 keys (Up/Down, Left/Right, Enter/Clear)
Vacuum Fluorescent Display (blue) - 2 lines of 40 characters
Internal IF loopback, RF loopback, digital loopback, and inward/outward loopback
Hardware fault, Rx and Tx Traffic Alarms, Open Network Backward Alarms
Type: Form C Contacts. Rating: Less than ± 15 volts up to 1 Amp
EIA-232 and EIA-485 (addressable multidrop, 2-wire or 4-wire)
SATMAC or CMCS software for control of local and distant units
1U high, 12 inches (305 mm) deep
10 lbs (4.5 kgs) max
25 watts (typical) 55 watts (maximum)
100 - 240 volts AC, +6%/-10% - autosensing
(total absolute max. range is 90 - 254 volts AC)
o o
0 to 50 C (32 to 122 F)
1