Setting Alarm Events; Figure 11-6 Alarm Inputs Screen; Figure 11-7 Alarm Inputs Connection - Honeywell HRDVS Reference Manual

Setting Alarm Events

HRDVS rear
alarm connector
Input 1
Input 2
Internal to HRDVS
Rev 2.00
The motion detection function is responsive, with both accurate and quick detection of
motion. However, the more cameras that use motion detection at the same time, the slower
the detection processing speed is. If multiple cameras are using motion detection
simultaneously, we recommend that each camera's motion detection be reviewed
individually during various activity periods to verify that the motion detection is performing
at the desired response level.
The HRDVS has two hardwired alarm inputs on the rear panel. For each input that is being
used, you need to set how you want the system to handle events. Alarm events can be
triggered by external alarm devices (for example, momentary switches or door contacts).
To set alarm events:
1. Set the alarm inputs on the Alarm Inputs screen as follows: Main Setup
Alarm Inputs. Figure 11-6
Figure 11-6 Alarm Inputs Screen
The HRDVS has two hardwired alarm inputs on the rear panel. Specify whether each
contact is normally open (NO) or normally closed (NC).
Figure 11-7 Alarm Inputs Connection
Inputs
To set NO/NC, see
1
Normally Open (NO).
If closed, alarm event is
detected.
2
1
Normally Closed (NC).
If open, alarm event is
detected.
3
External to HRDVS (Add this functionality yourself).
2. Access the Alarm Events screen as follows: Main Setup
➤
Recording Alarm Events.
displays.
Setting Alarm Events, page 67.
Figure 11-8 displays.
67
HRDVS Reference Guide
➤ ➤
Install
➤ ➤
Install Event
Document 900.0281
02/07