Table of Contents
Advertisement
User Access
Changing Passwords
Rev 2.00
Before you set up your HRDVS system, Honeywell recommends that you change the
default passwords and establish your initial user identification and permission levels.
To change a user password:
1.
Log on to the HRDVS (see
2.
Select the Change Password option; then press Enter.
Figure 5-1
Select a User Screen
3.
Press one of the Camera buttons for the desired user (for example, Camera 1 selects
User 1). The following dialog box displays.
4.
Enter a new numeric password. The password can be any combination of digits 1 to
4, up to 10 keystrokes long. Use the Camera buttons to enter your new numeric
password.
Note
If you do not wish to change your password at this time, press
the Cancel button, then press Enter.
5.
Press Enter. The Select a user dialog box reappears.
6.
Re-enter the same user name. The Confirm your new password dialog box displays.
7.
Confirm your new password by entering your new password again, then press Enter.
The User Permissions screen (see
you have successfully changed the password.
Entering Program
Mode, page 25).
Figure
5-2) for that user name displays, indicating
34
Figure 5-1
displays.
to highlight
Document 900.0281
02/07
Advertisement
Table of Contents
