Creating Extra Alarm Station Definitions For The Same Pc; Disconnecting When Alarms Are In Progress; Setting Up An Alarm Station For Alarm Callback - Honeywell Rapid Eye System Administration Manual

Multi-Media Alarm Stations

Creating Extra Alarm Station Definitions for the Same PC

Disconnecting When Alarms Are in Progress

Setting Up an Alarm Station for Alarm Callback

232
as: Fire sensors - local calls, Fire sensors - long distance, and so on. You can then add
the alarm station most appropriate for a site, on a site-by-site basis. Creating alarm station
definitions is explained in
Adding an Alarm Station Name and
For more information, see
Assigning a Site to Many Alarm Stations
A Multi SA has the option of creating two (or more) alarm station definitions to shuttle alarms
to the same PC (for example, one for local sites, and another for remote sites). To avoid
complexity, use descriptive names such as: local sensors and remote sensors. To create
alarm station definitions, see
Closing View or disconnecting a session after a successful alarm callback voids that
callback. This can occur due to power failure, user action, and so on. You can still view the
alarms in an alarm session.
If you have set up your alarm handling options to Automatically Rearm Alarms (see
Overview of Automatic Clip Creation and Rearm Features
be automatically rearmed if the unit is disconnected during a session. You will have to open
another alarm session to manually rearm the alarms.
Successfully Listing Alarm Callbacks After an Interruption
Run View and start an alarm session to list and work with the alarms. See the
Multi-Media Digital Video Recorder Remote View Operator Guide
Alarm session.
Keep the following points in mind when setting up an Alarm Station for alarm callback:
• At any point during alarm callback, only one Alarm Station can have Alarm callbacks
reported at one time even if we have multiple Alarm stations configured for a unit.
Alarm Stations will be notified in the sequence that you setup (see
on page 57).
Stations and Priority
• If an Alarm session is kept open in the Remote View application in any of the user
PCs, then the Alarms are reported in the Alarm session only, rather than to Alarm
Callback stations. Open Alarm sessions take the first priority (see
Priority for Alarm Notification
callbacks will go to the Alarm station.
Addressing Alarms to an Alarm Station
on page 58.
Adding an Alarm Station Name and Reports
on page 210). If no alarm sessions are open, alarm
Reports, page 216.
on page 57, and
Quickly
on page 216.
on page 233), the alarms will not
Rapid Eye™
to find out how to run an
Cascading Alarm
Setting Response