Setting Motion Events; Figure 11-3 Motion Event Screen (Hrdvs16 Shown) - Honeywell HRDVS Reference Manual

Field (cont'd)
Camera Homing

Setting Motion Events

Field
Enable
Camera Rate (fields/sec)
Event Text
Rev 2.00
Description
Note This feature is not available on the HRDVS1.
Enables or disables (default) camera homing for motion, text, and alarm events.
When enabled and:
System HRDVS is
detects ... programmed to ...
Motion event Record motion events
Text event Record text events
Before you use motion events, you must enable them for each camera and enter some
basic settings. For more information on how a motion event triggers an event video clip to
be recorded, see General Event
To set up motion events:
1. Access the Motion Event screen as follows: Main Setup
➤
Recording Motion Events.
Figure 11-3 Motion Event Screen (HRDVS16 Shown)
2. Use the following table to set motion events for up to four input ports.
Description
Enable or disable each Motion input port (1 to 16).
Specify the number of fields per second that should be recorded by the selected
camera.
Assign a title to each motion event. This text is used when you create a report (see
Creating a Report, page 94) or review events (see
The main monitor
displays ...
The recording motion camera for a timed
period or as long as motion is detected
(as set in the Motion Event screen).
The associated camera for that text event
for the duration (as set in the Text Event
screen).
Setup, page 61.
Figure 11-3 displays.
The number of camera buttons
in this field depends on your
HRDVS model.
General Event
63
HRDVS Reference Guide
➤ ➤
Install Event
Setup, page 61).
Document 900.0281
02/07