Activating Configuration Changes; Exiting Program Mode - Honeywell HRDVS Reference Manual

Activating Configuration Changes

Exiting Program mode

Rev 2.00
The text you are changing shows at the top of the Text Entry screen. The individual
letter you are currently changing is highlighted.
To move between characters in the text, use the front panel control buttons to access
the arrow buttons at the bottom of the Text Entry screen. The arrow buttons allow you
to move forward and backward in the text.
3. Change the text by moving to the different buttons on the Text Entry screen using the
front panel control buttons. Select a desired button, then press Enter.
4. When you are finished changing the text, select Accept to confirm your changes and
exit the Text Entry screen.
Whenever you make changes to an editable screen, you must press Enter to confirm the
change. When you have completed all desired changes to a screen, select Accept, then
press Enter to activate your configuration choices.
To exit Program mode, highlight Exit on the Main Setup screen (see
Enter. The system automatically exits Program mode and starts recording again after five
minutes of inactivity.
29
HRDVS Reference Guide
Figure 4-2), then press
Document 900.0281
02/07