Honeywell HRDE4X4 Quick Installation Manual

HRDE4X4 Quick Installation Guide
1
Easy Video / Audio Connections — Set Composite / VGA Monitor and

Start Recording

TO REDUCE T HE RISK OF FIRE OR ELECTRIC
SHOCK DO N OT EXPOSE T HIS APPLIANCE TO
RAIN OR MOISTURE
TO REDUCE T HE RISK OF ELECTRIC SHOCK
NO USER SE R VICEABLE PARTS INSIDE . REFER
SERVICINGTOQUALIFIED SE R VICE PERSONNEL
!
Connect the supplied 12 VDC power adapter to the unit, connect the AC 100 – 240 VAC 50/60 Hz adapter.
"
Connect cameras to Video IN BNC connectors.
#
Connect audio to Audio IN RCA connectors (use an amplified microphone).
$
Connect a monitor to the Video Out or VGA connector:
A monitor can be VGA (PC Monitor) or Composite (but not both at the same time). Unit is factory set for composite.
Set switch 2 down to ON and power reset the unit to change to VGA (composite stops working).
The HRDE4X4 is factory set to continuously record an estimated 21 days in a loop at 1 image per second, per
camera, with quad resolution and high image quality. On power up, if factory set and cameras are connected, the
unit begins recording automatically.
2
View Live Cameras, Listen to Live Audio and Record Indicator Status
Press SEQ in Audio from the selected camera will be heard.
single view to Audio must be enabled in the Record menu. An
automatically amplified speaker must be connected to the
rotate through Audio Out connection on the back of the unit.
each camera
For additional operations, see the
view. Press SEQ
Front Panel Operator Guide
again to stop.
included with the unit.
3
Access Programming Menus — Set the Date and Time
To log on, press 1111
Use arrow keys to highlight as required
Document 900.0573 – 02/06 – Rev 1.00
CAUTION
RISK OF ELECTRIC SHOCK
RS-422/485
DO NOT OPEN
WARNING
TX+ TX- RX+ RX-
CAUTION
1
ETHERNET
or User Guide
AUDIO IN # VIDEO IN
"
CH1 CH2 CH3 CH4 CH1
G 2 G 3 G 4 G OUT
CH3
SENSOR ALARM AUDIO OUT
Press SEL to
display quad
(4) cameras
Press arrow
key 1 – 4 to
select/display
one camera
C = Continuous recording in progress, Record Menu
R = Manual recording overide in progress (1 IPS)
HRDE4X4 M = Motion recording in progress
S = Sensor recording in progress (alarm input)
Set the date and time in the System menu
CH2
!
$
RS-232
P V
A G
L A
1 2
CH4
VIDEO OUT VGA DC 12V