Table of Contents
Advertisement
Installation
Label
Connection description
Text Insertion/
Connect the serial interface of a POS/ATMs/cash registers, door card reader access, or
Remote Access
other DB9 EIA232 ASCII source.
OR
MPT/MPT400N
Connect an external modem or a null modem cable.
Alarm In/Out
Connect one or two external alarm devices to the HRDVS alarm input.
Connect the HRDVS alarm output to trigger an external device.
PC Card
Insert approved PCMCIA card for network or modem connectivity. Card validation occurs
during system powerup, and can be verified on the System Information screen (see
page
PCMCIA card (see
Power
The HRDVS can operate with power ranging from 100 to 210 VAC, 50 to 60 Hz.
Alarm Connections
Alarm I/O Connector Pinouts
Alarm Connection Functionality
Rev 2.00
Table 3-1
Rear Panel Connections (cont'd)
22). You must enable remote access for the system to recognize and read the
Enabling Remote
The following section provides the alarm I/O connector pinouts and alarm connection
functionality.
The following table describes the Alarm I/O connector pinouts for the HRDVS.
Pin #
Name
1
Ground
2
Alarm Input 1
3
Alarm Input 2
4
Ground
5
Alarm relay output
6
Alarm relay output
The HRDVS has two hardwired alarm inputs on the rear panel. Specify whether each
contact is normally open (NO) or normally closed (NC).
Access, page 38).
16
Document 900.0281
02/07
Advertisement
Table of Contents
