Adjusting The Amount Of Slack At The Registration Roller - Kyocera Mita KM-3530 Service Manual

(2) Adjusting the amount of slack at the registration roller

Perform the following adjustment if the leading edge of the copy image is missing or varies randomly, or if the copy paper is
Z-folded during duplex copying.
Procedure
Start
Enter maintenance mode.
Enter "051" using the numeric
keys.
Press the start key.
Select "RESIST DATA".
Select "DUPLEX DATA".
Press the interrupt key.
Make a test copy in duplex mode.
Is the leading
edge of the image missing
or varying randomly
(copy example 1)?
No
Is the copy paper
Z-folded (copy example 2)?
No
Press the stop/clear key
to exit maintenance mode.
End
Press the start key.
The new setting is stored.
Yes
Increase the value using the
cursor up key.
Yes
Decrease the value using the
cursor down key.
Setting range: –30 to +20
Reference: 0
Changing the value by 1
changes the amount of slack
by 0.1 mm.
Initial setting: 0
The greater the value,
the larger the amount of slack;
the smaller the value,
the smaller the amount of slack
Original Copy
example 1
Figure 1-4-2
3CX
Copy
example 2
1-4-3