Setting Paper On The Multi-Bypass Tray - Kyocera Mita KM-7530 Operation Manual

Section 3 PREPARATIONS
NOTE
When you load paper into the drawer[cassette], the side facing
downward is the side that will be copied.
5 Insert the appropriate paper size label into the front of the
drawer[cassette] to indicate the size of paper that is loaded
into that drawer[cassette].
6 Gently push the drawer[cassette] back in.
NOTE
If you will not be using the copier for a prolonged period of time,
remove all paper from the drawers[cassettes] and seal it in its original
packaging in order to protect it against moisture.

(4) Setting paper on the multi-bypass tray

Up to 100 sheets of standard copy paper (75 g/m
size between 11" x 17"[A3] and 5
multi-bypass tray at one time. When copying onto special paper, be
sure to use the multi-bypass tray.
NOTE
The types of special paper and the number of sheets that can be set
on the multi-bypass tray at one time are as follows:
Tracing paper: 1 sheet
Letterhead: 100 sheets
Color paper: 100 sheets
OHP transparencies: 25 sheets
2
Standard paper (120 g/m , 160 g/m
IMPORTANT!
• When copying onto OHP transparencies, be sure to fan through
them a few times to separate the sheets before setting them on the
multi-bypass tray.
• When copying onto non-standard size paper, perform the procedure
in "(1) Paper size and type" on page 7-66 and select the paper size.
• When setting special paper such as OHP transparencies and thick
paper on the multi-bypass tray, the type of paper must be specified
under "(1) Paper size and type" on page 7-66.
3-4
2 2
– 80 g/m ), of a
" x 8 "[A6R] can be set on the
1/2 1/2
2
): 25 sheets
1 Open the multi-bypass tray.
NOTE
When copying onto paper of a size larger than 8
sure to pull out the multi-bypass extension.
2 Adjust the insert guides to fit the width of the paper that is to
be set on the multi-bypass tray.
3 Slide the paper all the way in, along the insert guides, as far
as it will go.
" x 11" or A4R, be
1/2