Adjustment After Roller And Clutch Replacement; Adjusting The Leading Edge Registration Of Image Printing - Kyocera Mita KM-1530 Service Manual

2AV/X

(6) Adjustment after roller and clutch replacement

Perform the following adjustment after refitting rollers and clutches.

(6-1) Adjusting the leading edge registration of image printing

Make the following adjustment if there is a regular error between the leading edges of the copy image and original.
U034
Caution:
Check the copy image after the adjustment. If the image is still incorrect, perform the above adjustments in maintenance
mode.
Procedure
• 20 cpm
Enter maintenance mode.
Enter "034" using the numeric keys.
Press the start key.
1-6
Select "Leading edge registration"
and press the start key.
Select the items to be adjusted using
the cursor up/down keys.
Press the interrupt key.
Press the start key
to output a test pattern.
Is the leading edge
registration correct?
Press the stop/clear key to exit
maintenance mode.
1-6-10
U066 U071
(P. 1-6-36) (P. 1-4-14)
Start
Message display
RCL ON
RCL ON 2 : Leading edge registration for when
RCL DUP : Leading edge registration for duplex
• After adjusting the leading edge registration for
regular operation (RCL ON), be sure to adjust
the leading edge registration for when paper
pauses at the registration roller (RCL ON2).
No
Yes
End
Leading edge registration
Correct image
: Leading edge registration
the paper pauses at the registration
roller
copying (second face)
Press the start key
The new setting is stored
For output example 1, decrease
the value using the cursor left key.
For output example 2, increase
the value using the cursor right key.
Setting range: –5.0 – +5.0
Initial setting: 0
Changing the value by 1 moves the
leading edge by 1.0 mm.
Output Output
example 1 example 2
Figure 1-6-19a