Detaching And Refitting The Press Roller - Kyocera Mita KM-1530 Service Manual

(6) Detaching and refitting the press roller

Follow the procedure below to replace the press roller.
Procedure
1. Remove the fixing unit (see page 1-6-48).
2. Remove the heat roller (see page 1-6-51).
3. Remove the screw holding the fixing guide
plate and then the plate.
4. Remove the press roller and two bearings.
5. Replace the press roller and refit all the
removed parts.
Fixing guide plate
Figure 1-6-81
Bearing
Press roller
Figure 1-6-82
2AV/X
1-6
Bearing
1-6-53