2AV/X
1-6-4 Main charging section
(1) Detaching and refitting the charger assembly
Follow the procedure below to replace the charger assembly.
Prucedure
1. Open the bypass tray, paper conveying unit
and front cover, and then remove the toner
cartridge and waste toner tank.
2. Remove the two screws and disconnect the
connector. While pressing the hook on the
front image formation cover, pull the image
formation unit out.
3. Remove the screw holding the charger
assemby and then the assembly.
4. Replace the charger assembly and refit all
the removed parts.
1-6
1-6-40
Connector
Hook
Image formation unit
Figure 1-6-53
Charger assembly
Figure 1-6-54