(5) Detaching and refitting the bypass paper width switch
Follow the procedure below to replace the bypass paper width switch.
Procedure
1. Remove the paper conveying unit and lower
left cover (see page 1-6-6).
2. Remove the bypass tray assembly.
3. Remove the two screws and then the upper
bypass cover.
4. Remove the gear and rack plate and detach
the connector and then remove the bypass
paper width switch.
5. Replace the bypass paper width switch and
refit all the removed parts.
• When replacing, apply the specified grease
to the printed surface of the new bypass
paper width switch.
• When refitting the gear, move the front and
rear rack plates to their innermost positions.
Figure 1-6-16
Rack plate
Gear
Bypass paper width switch
Figure 1-6-17
Rack plate
Gear
Rack plate
Figure 1-6-18
2AV/X
Upper bypass cover
Conector
1-6-9
1-6