(5) Detaching and refitting the heat roller
Follow the procedure below to replace the heat roller.
Procedure
1. Remove the fixing unit (see page 1-6-48).
2. Remove the fixing unit thermistor, fixing
heater and heat roller separation claw
assemblies (see pages 1-6-49 and 50).
3. Remove the two screws holding the eject
guide and then the guide.
4. Remove the two stop rings, collar, gear,
spring pin and bushing on the rear of the
eject roller and then remove the eject roller.
5. Remove the gear and detach the eject switch
connector.
Eject guide
Figure 1-6-75
Eject roller
Spring pin
Bushing
Figure 1-6-76
Figure 1-6-77
2AV/X
Stop ring
Gear
Stop ring
Collar
Gear
Connector
1-6-51
1-6