Ospf Host Route Settings - D-Link DGS-3600 Series User Manual
Layer 3 gigabit ethernet managed switch
Hide thumbs
Also See for DGS-3600 Series:
- Cli manual (431 pages) ,
- User manual (422 pages) ,
- Hardware installation manual (66 pages)
Table of Contents
Advertisement
Use the following parameters to configure the following settings for OSPF Area Aggregation Settings:
Parameter
Area ID
Network Number
Network Mask
LSDB Type
Advertisement
Click Apply to implement changes made.
OSPF Host Route Settings
OSPF host routes work in a way analogous to RIP, only this is used to share OSPF information with other OSPF routers. This is
used to work around problems that might prevent OSPF information sharing between routers. To add a new OSPF Route, click the
Add button. Configure the setting in the window that appears. The Add and Modify windows for OSPF host route settings are
nearly identical. The difference between them is that if you are changing an existing configuration you will be unable to change
the Host Address. To change an existing configuration, click on the corresponding Modify button in the list for the configuration
to change and proceed to change the metric or area ID.
To configure OSPF host routes, click L3 Features > OSPF > OSPF Host Route Settings, as shown below.
Use the window below to add an OSPF host route.
Specify the host route settings and click the Apply button to add or change the settings. The new settings will appear listed in the
OSPF Host Route Settings window. To view the previous window, click the
the previous window.
®
xStack
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Description
Allows the entry the OSPF Area ID for which the routing information will be aggregated. This
Area ID must be previously defined on the Switch.
Sometimes called the Network Address. The 32-bit number in the form of an IP address that
uniquely identifies the network that corresponds to the OSPF Area above.
The corresponding network mask for the Network Number specified above.
Specifies the type of address aggregation. The user may choose Summary or NSSA-EXT,
depending on the type of aggregation being configured. The default setting is Summary.
Select Enabled or Disabled to determine whether the selected OSPF Area will advertise it's
summary LSDB (Network-Number and Network-Mask).
Figure 8- 53. OSPF Host Route Settings table
Figure 8- 54. OSPF Host Route Settings – Add window
Show All OSPF Host Route Entries
200
link to return to
Advertisement
Table of Contents
