Interface Settings; Ipv4 Interface Settings - D-Link DGS-3600 Series User Manual

Interface Settings

The IP Address may initially be set using the console interface prior to connecting to it through the Ethernet. If the Switch IP
address has not yet been changed, read the introduction of the xStack
manual for more information. To change IP settings using the web manager users must access the IP Address window located in
the Administration folder.
The web manager contains two folders for which to setup IP interfaces on the switch, one for IPv4 addresses, named IPv4
Interface Settings, and one for IPv6 addresses, named IPv6 Interface Settings.

IPv4 Interface Settings

To view this window, click L3 Features > Interface Settings > IPv4 Interface Settings, as shown below.
To manually assign the Switch's IPv4 address and its related configurations, click the Add button, revealing the following window
to configure.
To modify an existing Interface, click that interface's Modify button, which will produce this window:
®
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
NOTE: After properly configuring an IP interface on the Switch, each
VLAN can be routed without any additional steps.
Figure 8- 1. IPv4 Interface Settings window
Figure 8- 2. IPv4 Interface Settings – Add window
®
DGS-3600 Series CLI Manual or return to Section 4 of this
155