Pim Candidate Rp Settings - D-Link DGS-3600 Series User Manual

To view the CBSR settings for an IP interface and set its BSR priority, click its corresponding Modify button, which will lead you
to the following window.
The following fields can be viewed or set:
Parameter
Interface Name
IP Address
Priority (-1 or 0-255)
Click Apply to set the priority for this IP Interface.

PIM Candidate RP Settings

The following window is used to set the Parameters for this Switch to become a candidate RP.
To view this window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM Candidate RP Settings, as shown
below.
The following fields can be viewed or set:
Parameter
Candidate RP Hold
Time (0-255)
®
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 8- 90. PIM Candidate BSR Settings – Edit window
Description
This read-only field denotes the IP Interface Name to be edited for its C-BSR priority.
Denotes the IP Address of the IP Interface Name to be edited for its C-BSR priority.
Used to state the Priority of this IP Interface to become the BSR. The user may select a
priority between -1 and 0 to 255. An entry of -1 states that the interface will be disabled to be
the BSR.
Figure 8- 91. PIM Candidate RP Settings window
Description
This field is used to set the time Candidate RP (CRP) advertisements are valid on the PIM-
SM enabled network. If CRP advertisements are not received by the BSR within this time
frame, the CRP is removed from the list of candidates. The user may set a time between 0
and 255 seconds with a default setting of 150 seconds. An entry of 0 will send out one
232