Igmp Snooping Group - D-Link DGS-3600 Series User Manual

VID
MAC Address
Unit – Port
Type
Next
Clear Dynamic Entry
View All Entry
Clear All Entry

IGMP Snooping Group

IGMP Snooping allows the Switch to read the Multicast Group IP address and the corresponding MAC address from IGMP
packets that pass through the Switch.
To view this window, click Monitoring > IGMP Snooping Group, as shown below:
The user may search the IGMP Snooping Table by entering the VLAN Name in the top left hand corner and clicking Find.
The following field can be viewed:
Parameter
VID
VLAN Name
Source
Group
Member Ports
Filter Mode
®
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
The VLAN ID of the VLAN the port is a member of.
The MAC address entered into the address table.
The Unit and port that the MAC address above corresponds to.
How the Switch discovered the MAC address. The possible entries are Dynamic, Self, and
Static.
Click this button to view the next page of the address table.
Clicking this button will clear Dynamic entries learned by the Switch. This may be
accomplished by VLAN Name or by Port.
Clicking this button will allow the user to view all entries of the address table.
Clicking this button will allow the user to delete all entries of the address table.
Figure 12- 30. IGMP Snooping Group Table window
NOTE: The Switch supports up to 4K IGMP Snooping groups.
Description
The VLAN ID of the VLAN.
The VLAN name which the member port belongs to.
Displays the status of the source filtering, which is the ability for a system to report the
interest in receiving packets from specific source addresses or sent to a particular multicast
address.
Specifies the multicast address of the multicast group.
The ports that are members of the multicast group.
The Filter Mode will display Include or Exclude depending on whether or not the multicast-
address has been configured to include or exclude the filter.
360