D-Link DGS-3600 Series User Manual page 276

incoming 802.1p user priority re-written to its original value before being forwarded by the Switch.
For more information on priority queues, CoS queues and mapping for 802.1p, see the QoS
section of this manual.
Class (0-255) Entering a value between 0 and 255 will instruct the Switch to examine the class field of the IPv6
header. This class field is a part of the packet header that is similar to the Type of Service (ToS)
or Precedence bits field of IPv4.
Flow Label (0- Configuring this field, in hex form, will instruct the Switch to examine the flow label field of the
FFFFF) IPv6 header. This flow label field is used by a source to label sequences of packets such as non-
default quality of service or real time service packets.
The user may specify an IP address mask for the source IPv6 address by entering the IP address
Source IPv6
mask, in hex form.
Address
The user may specify an IP address mask for the destination IPv6 address by and entering the IP
Destination IPv6
Address address mask, in hex form.
Port The Access Rule may be configured on a per-port basis by entering the port number of the
Switch.
Use this to limit Rx bandwidth for the profile being configured. This rate is implemented using the
Rx Rate (1-
156249) following equation: 1 value = 64kbit/sec. (ex. If the user selects an Rx rate of 10 then the ingress
rate is 640kbit/sec.) The user many select a value between 1 and 156249 or No Limit. The default
setting is No Limit.
Time Range Tick the check box and enter the name of the Time Range settings that has been previously
configured in the Time Range Settings window. This will set specific times when this access rule
will be implemented on the Switch.
Counter Tick the check box and use the pull-down menu to employ the Counter that will count the packets
identified with this rule. Users must note that if the Counter is employed in the ACL Flow Meter
function, the Counter will automatically be disabled here, regardless of this setting.
To view the settings of a previously correctly configured rule, click
®
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 10- 20. Access Profile Entry Display window (IPv6)
in the Access Rule Table to view the following window:
258