D-Link DGS-3600 Series User Manual page 286

Source IPv6 Address
Destination IPv6
Address
Click Apply to implement changes made.
To establish the rule for a previously created CPU Access Profile:
To view this window, click ACL > CPU Interface Filtering > CPU Interface Filtering Table, as shown below.
In this window, the user may add a rule to a previously created CPU access profile by clicking the corresponding Add Rule
button of the entry to configure Ethernet, IPv4, Packet Content Mask, or IPv6.
Click the Add Rule button to continue on to the CPU Interface Filtering Rule Table window. A new and unique window, for
Ethernet, IP, Packet Content and IPv6 will open as shown in the examples below.
To change a rule for a previously created CPU Access Profile Rule:
The CPU Interface Filtering Rule Configuration window allows the user to create a rule for a previously created CPU Access
Profile.
®
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
The user may specify an IP address mask for the source IPv6 address by entering the IP
address mask, in hex form.
The user may specify an IP address mask for the destination IPv6 address by and entering
the IP address mask, in hex form.
Figure 10- 30. CPU Interface Filtering Table window - Add
Figure 10- 31. CPU Interface Filtering Rule Table window
268