Parameters Description - D-Link DGS-3600 Series User Manual

To remove a previously created rule, select it and click the
the Access Rule Configuration window will appear:
To set the Access Rule for Ethernet, adjust the following parameters and click Apply.
Parameters Description
Profile ID This is the identifier number for this profile set.
Mode Select Permit to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select Deny to specify that packets that do not match the access profile are not forwarded by
the Switch and will be filtered.
Select Mirror to specify that packets that match the access profile are mirrored to a port defined
in the Port Mirroring window. Port Mirroring must be enabled and a target port must be set.
Access ID (1-128) Type in a unique identifier number for this access. This value can be set from 1 to 128.
Type Selected profile based on Ethernet (MAC Address), IP address, Packet Content, IPv6 address.
®
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 10- 10. Access Rule Configuration window (Ethernet)
Auto Assign – Ticking this check box will instruct the Switch to automatically assign

an Access ID for the rule being created.
Ethernet instructs the Switch to examine the layer 2 part of each packet header.

IP instructs the Switch to examine the IP address in each frame's header.

Packet Content Mask instructs the Switch to examine the packet header.

IPv6 instructs the Switch to examine the IPv6 address in each frame's header.

button. To add a new Access Rule, click the Add Rule button, and
249