D-Link DGS-3600 Series User Manual page 89

The following parameters can set:
Parameter
Host IPv4 Address
SNMP Version
Community String or
SNMP V3 User Name
To add a new IPv6 entry to the Switch's SNMP Host Table, click the Add IPv6 Host button in the upper left-hand corner of the
window. This will open the SNMP Host Table Configuration window, as shown below.
The following parameters can set:
Parameter
Host IPv6 Address
SNMP Version
®
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 6- 49. SNMP Host Table Configuration window for IPv4
Description
Type the IPv4 address of the remote management station that will serve as the SNMP host
for the Switch.
V1 - This specifies that SNMP version 1 will be used.
V2 - To specify that SNMP version 2 will be used.
V3-NoAuth-NoPriv - To specify that the SNMP version 3 will be used, with a NoAuth-NoPriv
security level.
V3-Auth-NoPriv - To specify that the SNMP version 3 will be used, with an Auth-NoPriv
security level.
V3-Auth-Priv - To specify that the SNMP version 3 will be used, with an Auth-Priv security
level.
Type in the community string or SNMP V3 user name as appropriate.
Figure 6- 50. SNMP Host Table Configuration window for IPv6
Description
Type the IPv6 address of the remote management station that will serve as the SNMP host
for the Switch.
V1 - To specifies that SNMP version 1 will be used.
V2 - To specify that SNMP version 2 will be used.
V3-NoAuth-NoPriv - To specify that the SNMP version 3 will be used, with a NoAuth-NoPriv
security level.
V3-Auth-NoPriv - To specify that the SNMP version 3 will be used, with an Auth-NoPriv
security level.
V3-Auth-Priv - To specify that the SNMP version 3 will be used, with an Auth-Priv security
71