D-Link DGS-3600 Series User Manual page 265

The window shown below is the Access Profile Configuration window for IPv6.
This screen will aid the user in configuring the Switch to mask packet headers beginning with the offset value specified. The
following fields are used to configure the IPv6:
Parameter
Profile ID (1-14)
Type
Class
Flow Label
Source IPv6 Mask
Destination IPv6
Mask
Click Apply to implement changes made.
To view the configurations set for a previously created access profile, return to the Access Profile Table and click the
under the Display heading, corresponding to the access profile for which to view configurations. A window similar to the one
below will be displayed.
®
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 10- 6. Access Profile Configuration window (IPv6)
Description
Type in a unique identifier number for this profile set. This value can be set from 1 to 14.
Select profile based on Ethernet (MAC Address), IP Address, Packet Content or IPv6 address.
This will change the window according to the requirements for the type of profile.
Select Ethernet to instruct the Switch to examine the layer 2 part of each packet

header.
Select IP to instruct the Switch to examine the IP address in each frame's header.

Select Packet Content Mask to specify a mask to hide the content of the packet

header.
Select IPv6 to instruct the Switch to examine the IPv6 address in each frame's

header.
Ticking this check box will instruct the Switch to examine the class field of the IPv6 header.
This class field is a part of the packet header that is similar to the Type of Service (ToS) or
Precedence bits field in IPv4.
Ticking this check box will instruct the Switch to examine the flow label field of the IPv6 header.
This flow label field is used by a source to label sequences of packets such as non-default
quality of service or real time service packets.
The user may specify an IP address mask for the source IPv6 address by ticking the
corresponding box and entering the IP address mask.
The user may specify an IP address mask for the destination IPv6 address by ticking the
corresponding box and entering the IP address mask.
247
button