D-Link DGS-3600 Series User Manual page 270

Configure the following Access Rule Configuration settings for IP:
Parameter Description
Profile ID This is the identifier number for this profile set.
Mode Select Permit to specify that the packets that match the access profile are forwarded by the Switch,
according to any additional rule added (see below).
Select Deny to specify that packets that do not match the access profile are not forwarded by the
Switch and will be filtered.
Select Mirror to specify that packets that match the access profile are mirrored to a port defined in
the Port Mirroring window. Port Mirroring must be enabled and a target port must be set.
Type in a unique identifier number for this access. This value can be set from 1 to 128.
Access ID (1-
128)

Selected profile based on Ethernet (MAC Address), IP address, Packet Content, or IPv6 address.
Type
This parameter is specified to re-write the 802.1p default priority previously set in the Switch, which
Priority (0-7)
is used to determine the CoS queue to which packets are forwarded to. Once this field is specified,
packets accepted by the Switch that match this priority are forwarded to the CoS queue specified
previously by the user.
Replace priority  Tick the corresponding check box to re-write the 802.1p default priority of a
packet to the value entered in the Priority field, which meets the criteria specified previously in this
command, before forwarding it on to the specified CoS queue. Otherwise, a packet will have its
incoming 802.1p user priority re-written to its original value before being forwarded by the Switch.
For more information on priority queues, CoS queues and mapping for 802.1p, see the QoS
section of this manual.
Replace DSCP Select this option to instruct the Switch to replace the DSCP value (in a packet that meets the
(0-63) selected criteria) with the value entered in the adjacent field.
Source IP Source IP Address - Enter an IP Address mask for the source IP address.
Destination IP Destination IP Address- Enter an IP Address mask for the destination IP address.
DSCP (0-63) This field allows the user to enter a DSCP value in the space provided, which will instruct the
Switch to examine the DiffServ Code part of each packet header and use this as the, or part of the
criterion for forwarding. The user may choose a value between 0 and 63.
Protocol This field allows the user to modify the protocol used to configure the Access Rule Table;
depending on which protocol the user has chosen in the Access Profile Table.
Port The Access Rule may be configured on a per-port basis by entering the port number of the switch
in the switch stack into this field. When a range of ports is to be configured, the Auto Assign check
box MUST be ticked in the Access ID field of this window. If not, the user will be presented with an
error message and the access rule will not be configured. The beginning and end of the port list
range are separated by a dash. For example, 3 specifies port 3. 2-4 specifies the range of ports
from 2 to 4.
Use this to limit Rx bandwidth for the profile being configured. This rate is implemented using the
Rx Rate
following equation: 1 value = 64kbit/sec. (ex. If the user selects an Rx rate of 10 then the ingress
®
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Auto Assign – Ticking this check box will instruct the Switch to automatically assign an
Access ID for the rule being created.
Ethernet instructs the Switch to examine the layer 2 part of each packet header.

IP instructs the Switch to examine the IP address in each frame's header.

Packet Content Mask instructs the Switch to examine the packet header.

IPv6 instructs the Switch to examine the IPv6 address in each frame's header.

252