D-Link DGS-3600 Series User Manual page 287

Figure 10- 32. CPU Interface Filtering Rule Configuration window (Ethernet)
To set the CPU Access Rule for Ethernet, adjust the following parameters and click Apply.
Parameters Description
Profile ID This is the identifier number for this profile set.
Select Permit to specify that the packets that match the access profile are forwarded by the
Mode
Switch, according to any additional rule added (see below).
Select Deny to specify that packets that do not match the access profile are not forwarded by the
Switch and will be filtered.
Access ID Type in a unique identifier number for this access and priority. This value can be set from 1 to
100.
Type Selected profile based on Ethernet (MAC Address), IP address, Packet Content Mask or IPv6.
VLAN Name Allows the entry of a name for a previously configured VLAN.
Source MAC Source MAC Address – Enter a MAC Address for the source MAC address.
Destination Destination MAC Address – Enter a MAC Address mask for the destination MAC address.
MAC
802.1p (0-7) Enter a value from 0 to 7 to specify that the access profile will apply only to packets with this
802.1p priority value.
Ethernet Type Specifies that the access profile will apply only to packets with this hexadecimal 802.1Q Ethernet
type value (hex 0x0-0xffff) in the packet header. The Ethernet type value may be set in the form:
hex 0x0-0xffff, which means the user may choose any combination of letters and numbers
ranging from a-f and from 0-9.
®
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Ethernet instructs the Switch to examine the layer 2 part of each packet header.

IP instructs the Switch to examine the IP address in each frame's header.

Packet Content Mask instructs the Switch to examine the packet header.

IPv6 instructs the Switch to examine the IPv6 part of the packet header.

269