Ospf Host Route Settings - D-Link xStack DGS-3120 Series Reference Manual

xStack® DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch Web UI Reference Guide
Network Mask
LSDB Type
Advertise
Click the Apply button to accept the changes made.
Click the Edit button to re-configure the selected entry.
Click the Delete button to remove the selected entry.

OSPF Host Route Settings

This window is used to configure OSPF host route settings.
To view the following window, click L3 Features > OSPF > OSPFv2 > OSPF Host Route Settings, as shown
below:
The fields that can be configured are described below:
Parameter
Host Address
Metric (1-65535)
Area ID
Click the Apply button to accept the changes made.
Click the Edit button to re-configure the selected entry.
Click the Delete button to remove the selected entry.
OSPF Default Information Originate Settings
This window will change the status of the originating OSPF default external route.
To view this window, click L3 Features > OSPF > OSPFv2 > OSPF Default Information Originate Settings as
shown below:
The fields that can be configured are described below:
The network mask that uniquely identifies the network that corresponds to the OSPF
Area.
The type of address aggregation. Options to choose from are NSSA Ext and Summary.
Allows for the advertisement trigger to be enabled or disabled.
Figure 5-52 OSPF Host Route Settings window
Description
Specifies the host's IP address used.
Enter a metric between 1 and 65535, which will be advertised.
Enter a 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely
identifies the OSPF area in the OSPF domain.
Figure 5-53 OSPF Default Information Originate Settings window
202