Using A Ktd-405/Ktd-405-2D Keypad - Interlogix TruVision DVR 20 User Manual

If there is only one TVR 20 used, the default DVR button is 1. If more
Note:
than one TVR 20 is used, they must each be first allocated an ID for remote
control. See "Audio, remote control, language settings and playback replay
time" on page 97 for more information.
Troubleshooting the remote control:
If the remote control is not functioning properly, perform the following tests:
• Check the battery polarity.
• Check the remaining charge in the batteries.
• Check that the remote control sensor is not masked.
If the problem still exists, please contact your administrator.

Using a KTD-405/KTD-405-2D keypad

Use the keypad to carry out functions similar to the front panel buttons. We use
the KTD-405/KTD-405-2D keypad controller (Figure 2) in this manual. For
detailed keypad instructions, refer to the KTD-405/KTD-405-2D Controller
Keypad User Manual.
Setting up a KTD-405 keypad to work with the TVR 20
To set up a KTD-405 keypad to work with the TVR 20:
1. Press and hold the set key of the keypad until Enter programming code
displays.
2. At the code entry display, enter the programming code 9, 5, 1. Then press the
seq button.
3. At the first menu display, press 1 to select the option Switcher/ MPLX.
4. At the Switcher/MPLX screen, press 2 to select the option Calibur.
5. At the Enter Calibur Address screen, enter the bus address of the TVR 20.
See the section "RS-232 and RS-485 port settings" on page 96 for
information on the bus address of your TVR 20.
To access the PTZ camera's programming menus using a KTD-405 keypad:
1. Switch the keypad to the camera you want to program.
2. Press and hold the set key until Enter programming code displays.
3. At the code entry display, enter the programming code 9, 5, 1. Then press the
seq button.
4. At the first menu display, press 3 to select the option Camera.
TruVision DVR 20 User Manual
51BChapter 4: Operating instructions
29