Connecting A Ktd-405 Keypad And Dome Camera To The Recorder - Interlogix TruVision DVR 12 User Manual

Connecting a KTD-405 keypad and dome
camera to the recorder
Use the input/output box that is supplied with the keypad to connect the KTD-405
keypad to the recorder. See Appendix D "KTD-405 keypad" on page 133 for
more information on wiring and using the KTD-405 keypad.
As the KTD-405 keypad uses full duplex data communication, you cannot
connect the both keypad and a dome camera directly to the recorder from the
RS-485 port as this could cause problems on the bus. If both devices are
required, it is recommended that you use the keypad's RS-422 connection to
connect the dome camera and the keypad's RS-485 connection to connect the
recorder. See Figure 5 as well as Table 4 and Table 5 below.
Note: These connections only work with UTC PTZ protocols (see Appendix B on
page 130). If you are using another manufacturer's PTZ protocol, it is not
possible to connect both a keypad and dome camera to the recorder.
Figure 4: Connecting a PTZ dome camera and KTD-405 keypad to the recorder
1. KTD-405 keypad
2. RS-232 programming port
3. RS-485 and RS-422 in/out
4. RS-485 termination switch
TruVision DVR 12 User Manual
5. RJ45 cable control (use the cable provided with
the equipment)
6. I/O box
7. Recorder back panel
8. Dome camera
15