Table of Contents
Advertisement
2
2.4
Installation through Plug and Play
If the local connection (IEEE or USB) is made between the PC and the
copier, the printer driver can be installed through the "Plug and Play"
function.
For details of how to install the printer driver, see "Installing a Windows
Printer Driver" on page 2-1.
Note
Windows NT 4.0 does not support "Plug and Play".
Connecting the IEEE1284 (Centronics) Cable
<Available only if the Parallel Interface Kit is installed>
1
Make the connection after the copier and PC have been turned OFF.
2
Plug one end of the cable into the copier and fix the lock springs on
both sides of the connector.
3
Connect the other end of the cable to the PC.
4
The copier and PC are turned ON in that order.
Windows is started, the installation guide for the printer driver through
Plug and Play is automatically started on the PC.
5
Install the printer driver according as instructed by the "Add New
Hardware Wizard".
Connecting the USB Cable
Windows 98 and 98SE:
Following the instructions given in the "Add New Hardware Wizard" that
will be automatically started through Plug and Play, install the USB device
driver and then install the printer driver.
1
Connect the USB cable to the copier and PC with the Power Switch
ON.
2
The installation of the printer driver through Plug and Play is
automatically started on the PC.
3
Install the USB device driver according as instructed by the "Add New
Hardware Wizard".
2-20
Installing a Windows Printer Driver
Printer Controller Pi3505e Pi3505e/PS
Advertisement
Table of Contents
