Table of Contents
Advertisement
3
11
If the test prints normally, complete the procedure by clicking
close the Properties dialog box.
After you finish installing a printer with the above procedure, you can use
it just as you would any standard local printer. The printer can also be
used as a network printer by other Windows computers on your network
whose Windows NT 4.0 systems are configured the same way as
described above.
Configuration Procedure (Windows 2000/XP/Server 2003)
1
Install TCP/IP under Windows 2000/XP/Server 2003.
❍
Refer to the applicable Windows documentation for more
information.
2
Assign the IP parameters.
❍
See "Specifying the IP Address From the Copier's Touch Panel" on
page 3-2 for more information.
3
Use the procedure below to install the printer.
Installing the printer (Windows 2000/XP/Server 2003)
1
Install the printer driver following the instructions that come with the
installer. Make the new printer the default printer.
2
Right-click the new printer icon and select
3
Display the
4
Click
Add
This displays a list of available port types.
5
Select
This starts
6
Click
Next
7
On the
the
Printer Name or IP Address
❍
If the network you are on uses DNS (Domain Name Services), type
in the DNS name instead of the IP address.
3-8
Ports
tab.
Port.
Standard TCP/IP Port
Add Standard TCP/IP Printer Port
on the introduction page of the wizard.
Add Port
page, type the IP address of the Network Card into
Properties
from the list, and then click
Wizard.
box.
Printer Controller Pi3505e Pi3505e/PS
Network Settings
OK
to
from the menu.
New
Port.
Advertisement
Table of Contents
