4
Output Setting Dialog Box
This dialog box appears when you click the
button on the
punching, and folding.
(1)
(2)
(1) Staple
This setting is available only when the Built-in Finisher (FN-117) is
installed on the machine. You can use it to staple the pages of one
printed document at a time.
• Off
• Auto 2-points
• Top 2 points
• Left 2 points
• Corner
If you have the Saddle Kit (SK-1) equipped on the Built-in Finisher
(FN-117) , you can also configure the following settings in addition
to those described above.
• Center
• Crease
4-14
Configuring PCL Printer Driver Properties for Windows
Setup
tab. You can use it to configure stapling, hole
No page stapling
Pages are stapled at two points along the top
edge when landscape orientation is selected, or
along the left edge when portrait orientation is
selected.
Pages are stapled at two points along the top
edge.
Pages are stapled at two points along the left
edge.
Pages are stapled in upper left corner.
Pages are stapled in the center.
You can select Crease for the (3) Fold setting.
Detail of Output Setting
Printer Controller Pi3505e Pi3505e/PS
(3)