Before Using the Printer Driver
1.3
Configuration
The machine can be configured with the options described below.
Note
You can use either the Printer Controller (Pi3505e) or the Printer
Controller (Pi3505e/PS).
The Network Interface Card (NC-4) is required in order to use the
Printer Controller (Pi3505e) or Printer Controller (Pi3505e/PS).
G
Printer Controller (Pi3505e)
Makes it possible to use the machine as a PCL printer.
Printer Memory Circuit Board (32MB)
G
Printer Controller (Pi3505e/PS)
Makes it possible to use the machine as a PCL/PS printer.
Printer Memory Circuit Board (128MB)
CompactFlash Card
Reference (Other related options)
G
Network Interface Card (NC-4)
Makes it possible to use the machine as printer. Equipped with a USB
port and LAN cable port.
G
Parallel Interface Kit
Enables printing over a parallel connection (IEEE1284).
Note
The Network Interface Card (NC-4) must be installed in order to use
the Parallel Interface Kit.
G
Hard Disk Drive Kit (HDD-6)
For downloading fonts and storing them. Stores the Store to HDD and
Scan to HDD data.
Note
The Network Interface Card (NC-4) must be installed in order to use
the Hard Disk Drive Kit (HDD-6).
Printer Controller Pi3505e Pi3505e/PS
1
1-5