Table of Contents
Advertisement
Network Settings
8
Type the name of the port you want into the
click Next.
Note
When you type the IP address into the
Address
Port Name
port name as you want.
9
On the
and then click Settings.
10
On the Configure Standard TCP/IP Port Monitor dialog box, select
LPR
from the
11
Type
print
box.
Note
Make sure that the "SNMP Status Enabled" check box is cleared.
12
Click
OK
page.
13
Click
Next
14
Click the
the
Apply
15
Display the
16
If the test prints normally, complete the procedure by clicking
close the Properties dialog box.
After you finish installing a printer with the above procedure, you can use
it just as you would any standard local printer. The printer can also be
used as a network printer by other Windows computers on your network
whose Windows 2000/XP/Server 2003 systems are configured the same
way as described above.
Printer Controller Pi3505e Pi3505e/PS
box, the name of the port is automatically entered in the
box as IP_<IP address>, but you can change the
Additional Port Information Required
LPR Settings
in the name of the queue you want into the
to return to the
Additional Port Information Required
to display the next wizard page, and then click Finish.
Close
button of the Printer Ports dialog box, and then click
button of the Properties dialog box.
General
tab, and then print a test page.
Port Name
Printer Name or IP
page, select Custom,
box.
3
box, and then
Queue Name
OK
to
3-9
Advertisement
Table of Contents
