Configure The Ipv4 Settings - NETGEAR WAC720 Reference Manual

ProSAFE Dual-Band Wireless AC Access Points WAC720 and WAC730

Configure the IPv4 Settings

Note: For information about how to configure the IPv6 settings, see
Configure IPv6 Settings
WARNING:
If you enable the DHCP client, the IP address of the wireless access
point changes when you click the Apply button, causing you to lose
your connection to the wireless access point. You must use the
new IP address to reconnect to the wireless access point.
Tip: If you enable the DHCP client on the wireless access point, you can
discover the new IP address of the wireless access point by
accessing the DHCP server on your LAN, or by using a network IP
address scanner application.
To configure the IPv4 settings:

1. Select Configuration > IP > IP Settings.
2. Configure the IPv4 settings as explained in the following table:
Setting
DHCP Client
IP Address
on page 74.
Description
By default, the Dynamic Host Configuration Protocol (DHCP) client is enabled.
The wireless access point receives its IP address, subnet mask, and default
gateway settings automatically from the DHCP server on your network when you
connect the wireless access point to your LAN.
Enter the IP address of your wireless access point. The default IP address is
192.168.0.100. To change the address, enter an unused IP address from the
address range used on your LAN, or enable DHCP the server.
Initial Setup
18