New Repeater Programming - Icom ID-31A Advanced Instructions

Previous view
■ Repeater list programming
This section describes how to manually program new
repeater information into the repeater list.
The required setting items differ, depending on the re-
peater use. Be sure to confirm the required items, as
shown to the right.
NOTE: To program the repeater information into the
repeater list, the repeater call sign MUST be en-
tered.
D New repeater programming
1. Repeater group selection
q Push [MENU]
w Push D-pad( ) to select the root item ("DV Memo-

ry"), and then push D-pad(Ent).
D-pad
(Ent)
(�)
e Push D-pad( ) to select "Repeater List," and then

push D-pad(Ent).
• The repeater groups are displayed.
r Push D-pad( ) to select the desired repeater group

to be programmed, and then push D-pad(Ent).
• The repeater list of the selected repeater group is dis-
played.
t Push .
y Push D-pad( ) to select "Add," and then push D-

pad(Ent).
• REPEATER LIST EDIT screen is displayed.
* When you want to add a new repeater by editing a pro-
grammed repeater memory contents, select "Edit." In this
case, after programming, be sure to select "<<Add Write>>."
If you select "<<Overwrite>>," the original repeater pro-
grammed contents are overwritten.
.
D Required items for the communication cases
Used as
Repeater list
an access
contents
repeater
NAME -
SUB NAME -
CALL SIGN
✔
GW CALL
✔
SIGN (For Gateway call)
GROUP -
USE(FROM)
✔
FREQUENCY
✔
DUP
✔
OFFSET FREQ
✔
POSITION -
LATITUDE -
LONGITUDE -
UTC OFFSET -
This item MUST be blank.
* 1
This item MUST be set to "OFF."
* 2
4-21
DR MODE <ADVANCED>
Used as a Used for a
destination simplex com-
repeater munication
-
-
-*
✔
✔
-
-
-
- -*
-
-
-
-
-
Select
*
☞ Continued on the next page.
4
-
-
1
-
-
1
✔
✔
2
2
-
3
-
-
4
-
-
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21