Frequency Offset Programming - Icom ID-31A Advanced Instructions

Previous view
4
DR MODE <ADVANCED>
Repeater list programming (Continued)
■
9. Duplex direction setting
• This item appears only when "YES" is selected in
[7. Access repeater setting].
• "DUP–" is automatically set when the access re-
peater frequency is programmed in [8. Access re-
peater frequency programming].
• If necessary, you can change the duplex direction.
#6 Push D-pad( ) to select "DUP," and then push D-

pad(Ent).
#7 Push D-pad( ) to select the duplex direction.

• OFF : Turn the duplex function OFF.
For a simplex operation, this item MUST be set
to "OFF."
• DUP– : The transmit frequency shifts down from the re-
ceive frequency by the offset amount.
• DUP+ : The transmit frequency shifts up from the re-
ceive frequency by the offset amount.
#8 After setting, push D-pad(Ent).

10. Frequency offset programming

• This item appears only when "YES" is selected in
[7. Access repeater setting].
• The offset value* is automatically set when the ac-
cess repeater frequency is programmed in [8. Ac-
cess repeater frequency programming].
*The default value is differ depending on the version.
• If necessary, you can change the frequency off-
set.
#9 Push D-pad( ) to select "OFFSET FREQ," and then

push D-pad(Ent) to enter the frequency offset edit
mode.
• A cursor appears and blinks.
$0 Rotate [DIAL] to input the frequency offset.
$1 Push to move the cursor backward, or push
move the cursor forward.
$2 Repeat steps $0 and $1 to enter the frequency off-
set.
$3 After entering, push D-pad(Ent).
11. Position data accuracy level setting
When the Repeater Search function is not used, or
the distance between your position and a repeater
is not displayed, select "OFF."
$4 Push D-pad( ) to select "POSITION," and then

push D-pad(Ent).
$5 Push D-pad( ) to select the position data accuracy

level.
• None : Select when the repeater has no position
data.
• Approximate: Select when the programmed position
data is approximate.
• Exact : Select when the programmed position
data is exactly correct.
$6 After setting, push D-pad(Ent).
to
4-26