Scan Items - Icom ID-31A Advanced Instructions

Previous view
10
MENU SCREEN OPERATION

■ Scan items

Pause Timer
Scan > Pause Timer(PAUSE TIMER)
Selects the scan Pause time. When receiving a signal, the scan pauses
according to the scan Pause timer.
• 2–20sec : When a signal is received, the scan pauses for 2 to 20 seconds
(set in 2 seconds steps).
• HOLD : When receiving a signal, the scan pauses until it disappears.
Resume Timer
Scan > Resume Timer(RESUME TIMER)
Select the scan Resume Timer.
When a received signal disappears, the scan resumes according to the
scan Resume Timer.
• 0sec : The scan resumes immediately after the signal disappears.
• 1 to 5sec : The scan resumes 1 to 5 seconds after the signal disap-
pears.
• HOLD : The scan remains paused according to the Pause Timer, even
if the signal disappears.
NOTE: Rotate [DIAL] to resume the scan.
The Resume Timer must be set shorter than the Pause Timer, otherwise
this timer does not work properly.
Program Skip
Scan > Program Skip(PROGRAM SKIP)
Turn the Program Skip Scan function ON or OFF for a VFO mode scan.
This function enables the transceiver to skip the unwanted frequencies or
channels that inconveniently stop scanning.
The unwanted frequencies or channels should be set to "PSKIP" in the
Memory Channel screen.
• OFF : The transceiver scans all frequencies without skipping.
• ON : The transceiver does not scan frequencies set as "PSKIP" frequen-
cies.
When the skip setting is ON "PSKIP" appears on the channel number.
10-14
(Default: 10sec)
(Default: 2sec)
(Default: ON)