D Setting The Duplex Direction; Off Band Indication - Icom ID-31A Advanced Instructions

Previous view

D Setting the duplex direction

Push [V/MHz]
q
Push [FM/DV]
w
mode.
Rotate [DIAL] to set the operating frequency.
e
Push .
r
Push D-pad( ) to select "DUP," and then push D-
t
pad(Ent).
D-pad
(Ent)
(�)
Push D-pad( ) to select "DUP–" (negative offset) or
y
"DUP+" (positive offset), and then push D-pad(Ent).
• OFF : For simplex operation (the receive and transmit
frequencies are the same).
• –DUP : The transmit frequency shifts down from the re-
ceive frequency by the offset amount.
• +DUP : The transmit frequency shifts up from the receive
frequency by the offset amount

■ Off band indication

If the transmit frequency is out of the amateur band,
the off band indication, "OFF," appears on the display
when [PTT] is pushed. Check the frequency offset (p.
1-4) or duplex direction (see above) in this case.
to select the VFO mode.
several times to select the FM
REPEATER AND DUPLEX OPERATIONS
1-5
1
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21