D From" (Access Repeater) Setting Using The Dr Mode Scan - Icom ID-31A Advanced Instructions

Previous view
3
DR MODE <BASIC>
"FROM" (Access repeater) setting (Continued)
■
D "FROM" (Access repeater) setting using the DR mode scan
The DR mode scan is useful to find a repeater.
To quickly find a repeater, the DR mode scan skips
repeaters that are not specified as an access repeater.
("USE (FROM)" setting is "NO" on the repeater list.)
Example: Select the "Hirano430" repeater using the
DR mode scan
Hold down
q
• The DR mode is selected.
Hold down [SCAN]
w
• The frequency decimal point and "FROM" blink while
scanning.
• The repeaters in the repeater list are
played.
• The scan pauses when a signal is received. The scan
resumes the same as other scanning. (p. 10-14)
When the transceiver receives a signal from a re-
e
peater, and stops at "Hirano430," push [CLR]
• The DR mode scan is cancelled.
• "Hirano430" is displayed on "FROM."
NOTE: You can skip certain repeaters from a scan
target. You can also skip all repeaters in certain
groups from a scan. See page 4-32 for details.
NOTE: The DR mode scan scans simplex frequen-
cies if they are entered in the repeater list.
While receiving a signal on 438.010.
Blinks
for 1 second.
to start the DR mode scan.
sequentially dis-
.
While DR mode scanning
Blinks
While receiving a signal from a repeater
"Hirano430" setting is completed.
3-12
The repeaters
are sequential-
ly displayed.
Means "JM1ZLK"
is using the "Hira-
no430" repeater.